To set up a data call, you need to activate a PDP context which has information about the data connection parameters such as carrier APN, type of IP connection etc. First select 'Find Ports' to search for avaialble ports. Data received from m2msupport. Use the 'Network Selection' tab for this feature,. The 'AT Command Tester' will check whether the device is registered before dialing the call, The AT command sequence for outgoing call is shown below, Checking registration status AT Command Tester will check whether the modem is registered in the network before setting up the data connection. 
| Uploader: | Yokinos |
| Date Added: | 19 March 2005 |
| File Size: | 5.33 Mb |
| Operating Systems: | Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X |
| Downloads: | 71101 |
| Price: | Free* [*Free Regsitration Required] |
Network Selection Network selection enables the user to select the network that is available. Table of contents Tech Support.
OK Signal level is dbm. Once connected to the module, you can send AT commands from the 'Command Mode' tab In script mode, you can send multiple AT commands at a same time as shown below. The 'AT Command Tester' will check whether the device is registered before dialing the call, The AT command sequence for outgoing call is shown below, Checking registration status AT Command Tester will check whether the modem is registered in the network before setting up the data connection.
The 'Diagnostics' tab can be used to get some basic modem information such as signal strength, whether the modem is registered, operator info, connection status etc.
Here you can get all the PDP context stored on the device. You can test incoming and outgoing voice calls with AT Command Tester.
Here is the sequence of AT commands to set up data call. Setting up HTTP parameters. Then select the modem port xt press 'Connect'. You can create your own script and store it on your local computer.
AT Command Tester Application - Seeed Wiki
If a successful connection is established, AT Command Tester should get device info as shown below. You can create your own script and save it on the local machine.
Signal condition is commxnd. Then load tfster script and execute. The AT command sequence for outgoing call is shown below, Checking registration status OK Signal level is dbm. For incoming, call the modem from an external phone. It should list the port that your Arduino board is connected to. Once connected to the module, you can send AT commands from the 'Command Mode' tab. The default rate for the shield is set to Then press 'Connect' button.
The AT command sequence for outgoing call is shown below, Checking registration status AT Command Tester will automatically detect the incoming call and provide a prompt. The signal strength range is dbm Excellent to dbm Marginal.
AT Command Tester Application
Please submit any technical issue into our forum. Now you can send tster AT commands in the 'Command' tab or exercise any other features from the other tabs.
Then select the right baud rate. You can also send SMS message to a mobile number. Under the 'Script Mode' tab, you can send batch of AT commands. To set up a data call, you need to activate a PDP context which has information about the data connection parameters such as carrier APN, type of IP connection etc. Data received from m2msupport. Network selection is a feature that enables the user to manually select from the available networks.
The signal strength range is dbm Excellent to dbm Marginal. IP address is "
No comments:
Post a Comment